- The front panel features a single XLR/TRS combo connector that accepts an input from a microphone or instrument.
- Engage the phantom-power switch to send 48V phantom power to condenser mics or leave if off when connecting dynamic microphones.
- The accompanying control knob allows you to dial in gain from the built-in preamp for the mic signal. Connect headphones to the 3.5mm jack and dial in volume using the easy-to-reach knob.
- The rear panel features two 1/4″ TRS outputs to connect to powered monitor speakers.
- Control the line output level using the large top-panel dial.
- The 3.5mm line input connector allows you to connect a mobile device or similar audio source.
- A second 3.5mm input is used to connect microphones that don’t require power.
- Use the 3.5mm output jack here to stream to a mobile device.
- The micro-USB port and included cable can supply additional power when required.
Microphone Input | |
Total harmonic distortion plus noise | <0.0061% (-90dB) |
Dynamic range | 101dB (A weighting) |
Signal to noise ratio | -94dB (A weighting) |
Frequency response | 22Hz to 22kHz (+/-0.1dB) |
Adjustable gain range | +34dB |
Crosstalk | -87dB @1kHz |
Input impedance | Mic in 1.8K Ohms, typical |
Total gain range | +50dB |
Line output 1/2 (unbalanced) | |
Rated output level | Unbalanced: +4dBV, typical |
Load impedance | 600 Ohm minimum |
Dynamic range | 105dB (A weighting) |
Total harmonic distortion plus noise | <0.003% (-90 dB) |
Large output level | +11dBV, typical |
Signal-to-noise ratio | -100dB (A weighting) |
Frequency response | 22Hz to 22kHz (+/-0.1dB) |
Input impedance | 150 Ohm |
Crosstalk | 100dB@1kHz |
Headphone output | |
Frequency response | 22Hz to 22kHz (+/-0.1dB) |
Load impedance | 32 to 600 Ohms |
Signal to noise ratio | -90dB (A weighting) |
Total harmonic distortion plus noise | <0.03% (-70dB) |
Input impedance | 75 Ohm |